Default Values

SERIES 9130 Factory defaults
June 28, 2011.
Parameter	Default	Factory Setting	Customer Setting
Host 232 baud	19200
Host 232 Mode	Modbus/DF1 Master
Host 232-2 baud	19200
Host 232-2 Mode	Modbus
Host 485 baud	19200
Host 485 Mode	Modbus
Host 485 Address	1
Client 1 baud	19200
Client 1 Mode	Modbus
Client 2 baud	19200
Client 2 Mode	Modbus
Pass code 1	1
Pass code 2	2
Web code 1	111
Web code 2	222
Web change enable	yes
PV 1 Name	Temperature 1
Furnace Name	Temper 1,2, & 3

AD 1 filter time	0
AD 2 filter time	0
AD 3 filter time	0

IN 1 initial scale	0
IN 1 Full scale	1000
IN 2 initial scale	0
IN 2 Full scale	10000
IN 3 initial scale	0
IN 3 Full scale	10000


IN 1 Decimal place	0
IN 2 Decimal place	0
IN 3 Decimal place	0



Parameter	Default	Factory Setting	Customer Setting
Setpoint lower limit, all	-9999
Setpoint upper limit, all	29999
Event hold	none
Event hold polarity	all N.O.
Hold instrument	none
Hold PV min	2000
Hold PV max	0
Event run	None (-1)
Event reset	None (-1)
Client Instrument setups	None
Zone Assignments	None

Quench instrument	Instrument 2
Quench events	6 speed, 7 end
Temperature default wait limit	15
PV Switch Action	None
IP address	192.168.0.200
IP net mask	255.255.255.0
IP gateway	192.168.1.1
Temperature mode	Fahrenheit
Loop 1 setpoint	0
Loop 1 prop band	4.0
Loop 1 reset	0.1
Loop 1 rate	0
Loop 1 cycle time	60
Loop 1 auto/manual	auto
Loop 1 integral preset	0
Loop 2 setpoint	0
Loop 2 prop band	4.0
Loop 2 reset	0.1
Loop 2 rate	0
Loop 2 cycle time	60
Loop 2 auto/manual	manual
Loop 2 integral preset	0